Questions tagged [rubiks-cube]

For questions about the Rubik's Cube and its variations.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
10
votes
0answers
326 views

Can you provide a hint on how to solve this Hex Cube puzzle?

I've been tackling this puzzle named "Hex Cube" which comes with the instructions "Can you decipher the message? You should be able to if you go back to basics and use a little bit of ...
5
votes
0answers
297 views

Is there a term for ZZ with CFOP F2L?

CFOP is my preferred method for speedcubing. Recently I thought of learning ZZ. Although recognition of bad edges was difficult, it made F2L a whole lot easier. However I feel that the basic CFOP-...
3
votes
0answers
93 views

Designing a new type of twisty puzzle

Recently, I was fiddling with my Rubik's cube and tried scrambling it only using R and U moves. I then tried to solve it using only R and U moves. I didn't use any cube rotations. It was an ...
3
votes
0answers
259 views

What are the specific algorithms Feliks Zemdegs uses to solve a 3x3x3 Rubik's cube?

I apologise if this is not the right site to post this kind of question, but out of all SE sites this one yielded the most question concerning specific cubing algorithms (namely this, this, this, this ...
2
votes
0answers
554 views

What is the next method after 3-style in 3x3 Blindfolded?

I have been using the method 3-style for over 2 years, 3-style and I have settled in the range of 25-30 seconds. I wish to permanently become sub-20, and for that I am planning to undertake the ...
2
votes
0answers
356 views

How many known distance-20 positions are found so far for the Rubik's cube in half-turn metrics?

This site says: "All 93,659,370 known distance-20 positions as of 18 March 2014 are available below." And in total there are about 490 millions of them. This information is 3 years old. Does anybody ...
0
votes
0answers
245 views

Best strategy for Multiple Blindfolded 3x3 Rubik's Cube event (WCA)

The MBLD event is quite hard on the technique and the memory , testing the 3x3 Blindfolded method. The cube placement strategy as discussed by few officials stand at : Cube Placement The other ...
0
votes
0answers
259 views

How do I solve the first phase (corners) of the gear cube when only one corner is out of place?

I learnt that there are three phases involved in solving a gear cube, the first being the corners. In EVERY video I watched, when they get two of a layer's corners to match, the other two are ...